Grain-systems PNEG-526 User Manual download pdf (Page 153)

DAILY INSPECTION

Visually check the oil level gauge on the vertical

unit, forced

lubricated type. Check lubrication flow by

viewing piping set and oil signal (Part No. 41). Faulty

operation is caused by a lack of lubrication oil,

damage to the plunger pump (Part No. 42) or the

positive displacement pump (Part No. 43) or the

clogging of pipes, etc. In case of faulty operation, stop

and inspect the unit immediately.

A temperature rise of approximately 105°F (40.6%)

above ambient on the surface of the ring gear housing

(Part No. 2

01) is allowable if the temperature

fluctuation is

small. If temperature rises rapidly from a

stable condition, add the recommended oil or grease

(Tables A

7 and A-1

1).

A rapid temperature rise may

be caused from a lack of lubrication.

If after lubricating unit, the problem persists, stop

operation and consult

factory.

When an abnormal sound is heard from inside the

unit, stop operation and inspect the unit.

If the lubrication oil leaks, replace the damaged or

worn part with a new one. (Refer to Part No.

1-04H,

Page A

3.)

Ordering Correct Replacement Units Or Parts

The SM-CYCLOe is fully standardized to offer maximum

Name Plate on SM-CYCLO'

part interchangeability among models of the same frame

size. However, there are many frame sizes, models and

types in the production range of SM

CYCLO? Therefore

to get correct replacement units or parts, proper

information to identifv the

meed reducer in auestion is

S-

..-CYCLO"

CHESAPEAKE,

VIRGINIA

Storage And Operation After Storage

essential. The name'plate, which is secured'to the body

of the drive, provides this identifying data.

Please give the full description shown on the name plate

to your distributor. Be sure to include the

SERIAL

NUMBER and MODEL NUMBER. This information,

along with our production records, will enable us to

provide you with the correct replacement unit or parts.

Storage

Months

1 Year

Oil

Lubricated

MUUtL

RATIO SERVICE FACTOR

INPUT HP RPM

OUTPUT TORQUE IN

SERIAL NO.

SUMITOMO~%;~".'".EY~=~,~

Completely fill unit@) with a rust

preventive oil

(NP20 or equivalent) or a circulating oil (Shell VSI No.

100 or equivalent).

At approximately

month intervals, rotate the input

shaft a sufficient number of times to insure all internal

components remain coated. (The higher the ratio, the

greater the amount of rotations needed for proper

lubrication.)

Grease

Lubricated

Grease

lubricated models do not require any special

attention during storage. (Inspect unit before

operation.)

Operation After Storage

Months

1 Year

Oil

Lubricated

Completely drain the rust preventive, or circulating

oil from unit.

Flush unit with the recommended operating oil as

shown in Table

A-1 1.

After flushing, fill the unit to the proper oil level with

the recommended lubricating oil.

Grease

Lubricated

Add %of the recommended quantity of new grease as

shown in Table A

10.

Note:

Consult the factory before operating units stored

for periods greater than

year.

Note:

For both the Oil

Lubricatedand Grease-

Lubricated models, if units are to be stored for a

period exceeding 1 year, consult factory.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 191 192

Comments to this Manuals

No comments

Grain-systems PNEG-526 User Manual Page 153

Comments to this Manuals

Related products and manuals for Conditioners Grain-systems PNEG-526